F10 N55 Stage 1 for Aftermarket Inlets

Your N55's restrictive factory airbox becomes a bottleneck above 4,000 RPM, preventing your single turbo from reaching target boost and causing heat soak that kills power. This Stage 1 intake eliminates that restriction, feeding your turbo the cold, dense air it demands for consistent performance.

Performance Gains

Expect 10-15 HP and 15-20 lb-ft of torque gains with proper tuning, plus noticeably sharper throttle response throughout the rev range. The forward-facing filter design captures genuine ram air effect at highway speeds, while the heat-shielded construction prevents intake air temps from climbing during spirited driving. Your N55 will hold boost more consistently to redline and spool faster from low RPM.

Fitment

For this Stage 1 kit, you will need to fit your own elbow based on your inlet. BHP cannot guarantee fitment due to variances in custom inlet position and size. We are happy to help you source what you need.

N55:  F10 535i (2011-2016) 

Installation & Supporting Mods

Direct bolt-on installation takes 45 minutes with basic tools. Remove the factory airbox, install the new intake tube and filter assembly, reconnect your MAF sensor and you're done. No cutting or permanent modifications required. Works with stock or aftermarket inlets. Installation video and detailed instructions included. Need help planning your build or stuck mid-install? Text us at 813.252.1025 — we will walk you through it.

Shipping

Free shipping to the lower 48 states. International shipping available — contact us for a quote.